Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Kaneko, Tetsuji; Tsukatani, Ichiro; Kiuchi, Kiyoshi
JAERI-Research 2005-005, 23 Pages, 2005/03
Fuel elements used in The Reduced-Moderation Water Reactor (RMWR) have the lamellar structure consisting of MOX pellets and UO blankets in order to attain the high breeding ratio and high burn-up simultaneously. It is a characteristic of the fuel elements that there is high thermal stress caused by inhomogeneous linear power density along the longitudinal direction of the fuel rod. Therefore, it is important to evaluate the local deformation behavior due to the transient temperature distribution. To estimate the thermal deformation behavior, the temperature and stress distribution of the fuel cladding tube assumed in the designed reactor were analyzed. Moreover, basic physical properties and mechanical properties for analyzing the deformation behavior were obtained by experiment using fuel cladding tubes made of candidate alloys. In addition, the appropriate experimental conditions for realizing the practical thermal deformation behavior of the fuel cladding tube was selected by adjusting the testing temperature distribution based on data obtained with thermal analysis.
Kaneko, Tetsuji; Tsukatani, Ichiro; Kiuchi, Kiyoshi
JAERI-Tech 2004-035, 18 Pages, 2004/03
Fuel elements used in the Reduced-Moderation Water Reactor (RMWR) have the stacking structure consisting of MOX pellets and UO blankets in a fuel rod in order to attain the high breeding ratio and high burn-up simultaneously. It is a characteristic of the fuel elements that there is high thermal stress caused by inhomogeneous linear power density along the longitudinal direction of the fuel rod in comparison with the present LWR fuels. For this reason, it is important to estimate local deformation behavior of the fuel cladding tube with temperature difference caused by MOX pellet and UO blanket. The testing machine was designed to investigate thermal-fatigue behavior under biaxial stress condition. The testing machine consists of the temperature distribution control unit, low cycle fatigue testing unit and internal pressure loading unit, it is also possible to conduct the simulation tests to investigate effects of pressure change with burn-up and longitudinal load change due to operation modes and restriction of fuel rods.